%general-entities; ]> Module-Init-Tools Issue the following commands to perform the tests (note that the make distclean command is required to clean up the source tree, as the source gets recompiled as part of the testing process): ./configure && make check && make distclean Prepare Module-Init-Tools for compilation: ./configure --prefix=/ --enable-zlib --enable-zlib This allows the Module-Init-Tools package to handle compressed kernel modules. Compile the package: make Install the package: make INSTALL=install install INSTALL=install Normally, make install will not install the binaries if they already exist. This option overrides that behavior by calling install instead of using the default wrapper script. Installed programs depmod, generate-modprobe.conf, insmod, insmod.static, lsmod (link to insmod), modinfo, modprobe (link to insmod), and rmmod (link to insmod) Short Descriptions depmod Creates a dependency file based on the symbols it finds in the existing set of modules; this dependency file is used by modprobe to automatically load the required modules depmod generate-modprobe.conf Creates a modprobe.conf file from an existing 2.2 or 2.4 module setup generate-modprobe.conf insmod Installs a loadable module in the running kernel insmod insmod.static A statically compiled version of insmod insmod.static lsmod Lists currently loaded modules lsmod modinfo Examines an object file associated with a kernel module and displays any information that it can glean modinfo modprobe Uses a dependency file, created by depmod, to automatically load relevant modules modprobe rmmod Unloads modules from the running kernel rmmod